EnviroTex Lite® is a water clear 1:1 mix ration by volume epoxy resin used to coat surfaces. It cures to a long-lasting, high gloss coating in approximately 8 hours at 70°F, and reaches full strength and toughness in about 72 hours. This durable, resilient material requires no polishing to produce a high gloss. One coat is all that is usually required for an attractive finish, however, two or more coats maybe applied one over the other to build additional thickness. Read all instructions prior to use.
- The original 1:1 epoxy coating system since 1969
- Convenient 1:1 mix ratio by volume
- 20-30 minute working time / 8-12 hour tack-free time
- Full cure in 72 hours
- FDA Complaint (FDA 21 CFR 175.300) when accurately measured, thoroughly mixed, and fully cured.
- Self-levels to approximately 1/16"
- Produces a durable high-gloss surface coating for artwork, table tops, crafts, and more!
4 oz. Kit = 2 oz. A + 2 oz. B (covers 1 sq. ft.)
8 oz. Kit = 4 oz. A + 4oz. B (covers 2 sq. ft.)
16 oz. Kit = 8 oz. A + 8oz. B (covers 4 sq. ft.)
32 oz. Kit = 16oz. A + 16oz. B (covers 8 sq. ft.)
64 oz. Kit = 32oz. A + 32oz. B (covers16 sq. ft.)
1 gal. Kit = .5 gal. A + .5 gal. B (covers 32 sq. ft.)
The shine, the clarity, the perfection, especially for an amateur, are remarkable. I have no artistic talent. In fact, I'm in the negative numbers, I'm so bad at artsy things. This stuff makes me look like I not only know what I'm doing, but I excel at it. It is beautiful, enhancing everything I've used it on. Applying it to my hand-turned wood bowls achieves a museum-like finish. I can't believe it.
Awesome product, used it on new shuffleboard table, came out like glass
Do NOT purchase if making any artwork that will be exposed to any level of sunlight. Yellowing is to the extreme and the alcohol ink colors faded to virtually no color. For a senior on a fixed income, I just blew $106 on worthless resin. I just ordered ArtResin again and will stick with that brand as it does NOT yellow.
This product is worth the high rating, it pours like butter and dries like glass! If you have the patience and follow the instructions you will not be disappointed! I wish I could post pictures to this site. My sports bar and grill has a brand new, very lon bar top and this is the last step. Poured over hammered copper, and the results are stunning! Could not be happier
I have been using envirotex lite for years now. I use this epoxy resin to finish coat my inspirational plaques and products in my ministry. While the resin is somewhat pricey to obtain, when the directions are followed, this resin imparts a beautiful glossy finish.
Looks crystal clear when dried. make sure to wear gloves and put plastic down around project. could be less expensive
Awesome resin, must use warm in warm room. I even heat the mixing cup. Very little bubbles. Cures hard and quickly. Love it!